Table of Contents
Advertisement
DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Parameter
Invalid Time
Flush Time
Poison Reverse
Split Horizon
Click the Apply button to accept the changes made.
The fields that can be configured in Redistribute Settings are described below:
Parameter
Protocol
Metric
Click the Apply button to accept the changes made.
Click the Delete button to delete an entry based on the information entered.
RIPng Interface Settings
This window is used to display and configure the RIPng interface settings.
To view the following window, click L3 Features > RIPng > RIPng Interface Settings, as shown below:
The fields that can be configured are described below:
Parameter
Interface VLAN
State
Description
Select the Default option to use the default value here which is 30 seconds.
Enter the invalidate timer value in seconds here. The range is from 1 to 65535
seconds.
Select the Default option to use the default value here which is 180 seconds.
Enter the flush timer value in seconds here. The range is from 1 to 65535
seconds.
Select the Default option to use the default value here which is 120 seconds.
Select to enable or disable the Poison Reverse feature here. When Poison
Reverse is enabled, the routes learned from an interface will be advertised out
to the same interface with an unreachable metric.
Select to enable or disable the Split Horizon feature here. When Split Horizon is
enabled, the routes learned from an interface will be not advertised out to the
same interface.
Description
Select the protocol whose routes are to be redistributed here. Options to
choose from are Connected, OSPF and Static. The Static option means to
redistribute IPv6 static routes. The Connected option refers to routes that are
established automatically by virtue of configuring IPv6 address on an interface.
Enter the value to be used as the metric for the redistributed routes here. The
range is from 0 to 16.
Select the Default option to use the default metric value.
Figure 6-213 RIPng Interface Settings Window
Description
Enter the VLAN interface ID here. The range is from 1 to 4094. Select the All
Interface option to use all available interfaces in this configuration.
Select to enable or disable the IPv6 RIP feature on the VLAN interface
specified.
205
Advertisement
Table of Contents
