Removal; Videomed Dc; I.i. Mini Voltage Supply - Siemens SIREMOBIL Iso-C Service Instructions Manual

Replacing boards / replacing components

Removal

WARNING
CAUTION

VIDEOMED DC

•
Move the I.I. into the service position. Refer to chapter 1, I.I. service position.
•
Remove the Videomed DC and place it on a clean surface.
•
Cover it to prevent contamination. Refer also to chapter 6, VIDEOMED DC.

I.I. mini voltage supply

•
Remove the I.I. mini voltage supply and lay it down on a suitable surface
(Control section and high voltage section).
•
Refer to chapter 6, Replacing the I.I. mini voltage supply.
•
Dissipate any residual voltage in the cables by shorting them to ground.
•
Remove the O-ring and the cap nut from the anode cable.
•
Remove the plug for the cassette contact.
•
Disconnect all the cables (protective conductor, cable to VIDEOMED DC, etc.....) from
the I.I.
•
At the same time, remove the cable ties or the cable clamps.
•
Pull all the cables inside the C-arm.
Siemens AG
Medical Solutions
Risk of injuries on mechanical parts!
If not observed, slight to medium injuries, especially to the hands,
can occur.
Observe the notes concerning the C-arm carbon fiber structure.
Risk of injury!
Noncompliance can lead to light to medium injuries and/or
property damage.
The C-arm covers contain counterbalance weights and weigh
approx. 6 kg.
Hold the covers firmly when installing or removing them.
Before the C-arm cover will be loosened, the C-arm must be
moved to its middle orbital position.
If the C-arm covers are loosened, the C-arm may not be moved to
its orbital end positions (I.I. or SIREPHOS at the orbital end posi-
tion).
SPR2-230.061.01
Rev. 13
Page 13 of 48
12.04 CS PS 24
6 - 13
6
6
6
SIREMOBIL Iso-C
System Manual