Huawei FusionModule1000A40 Installation Manual page 89

FusionModule1000A40 Prefabricated All-in-One
Data Center
Installation Guide
● The SIM card needs to support the Global System for Mobile Communications
(GSM) and Wideband Code Division Multiple Access (WCDMA).
● The 4G antenna required by the SMS function needs to be purchased.
Skill requirement: common technician
Procedure
Step 1 (Optional) Remove the ECC800 main control module and install the Micro SD card
and SIM card in the slot on the left side.
1.
2.
3.
4.
Step 2 Install an antenna.
1.
2.
Issue 07 (2022-12-15)
NO TICE
Loosen the screws on both sides of the ECC800 main control module.
Pull the handles on both sides of the ECC800 main control module, and
remove the main control module.
Figure 9-7 Removing the ECC800 main control module
Install the Micro SD and SIM card in the corresponding slot of the ECC800
main control module.
Figure 9-8 Installing the Micro SD and SIM card
Reinstall the ECC800 main control module in the ECC800 subrack.
Pull the indexing plunger handles at the front and rear of the sliding bases of
cabinets in row A.
Turn the indexing plunger handles at the front and rear of the sliding bases
by 90° to unlock the handles.
Copyright © Huawei Digital Power Technologies Co., Ltd.
9 Installing Devices Inside Pre-fab. Modules
81