Connecting The Cable To The Battery Of The Fire Control Panel - Huawei FusionModule1000A40 Installation Manual

FusionModule1000A40 Prefabricated All-in-One
Data Center
Installation Guide
2.
----End

9.4.1.2 Connecting the Cable to the Battery of the Fire Control Panel

Prerequisites
The pre-fab. modules have been installed.
Preparations
The fire control panel battery has been installed before delivery. You only need to
connect the reserved cable to the battery onsite.
Tools: protective gloves
Materials: none
Skill requirement: common technician
Procedure
Step 1 Open the door of the fire control panel.
Step 2 Remove the protective foam from the battery and check whether the battery is
intact or leaks.
If the battery is damaged or leaks, contact Huawei technical support to replace
the battery.
Step 3 Connect the battery cables to the reserved power cable terminals.
Issue 07 (2022-12-15)
Figure 9-18 Operating the electrical actuator ejector
Remove the protective cover at the electrical actuator installation position on
the container valve. Align the electrical actuator and the container valve, and
tighten the electrical actuator clockwise
NO TICE
Copyright © Huawei Digital Power Technologies Co., Ltd.
9 Installing Devices Inside Pre-fab. Modules
89