Huawei FusionCol8000-C210 User Manual page 142

FusionCol8000-C210 In-room Chilled Water Smart
Cooling Product
User Manual (2022, Netherland GS)
Procedure
Step 1 On the home screen of the display module, tap Shutdown and turn off the unit
switch in the PDF.
Exercise caution because the unit is still energized after it is shut down on the
screen of the display module.
Step 2 Replace the display module.
● Do not frequently or quickly disconnect or connect the DP cable of the display
module. Do not forcibly pull the DP cable.
● You are advised to power off the main control board (or main control module)
and then replace the display module.
1.
2.
3.
4.
5.
Issue 01 (2022-12-30)
NO TICE
CA UTION
Open the front door with caution to prevent damaging the cables of the
display module.
Remove the cables from the display module.
Use a Phillips screwdriver to remove the four screws and gaskets that secure
the display module, and pull out the display module.
NO TICE
– When pushing the display module leftwards or rightwards, pay attention to
the buckles on the panel to prevent damage to the display module.
– The gasket is used to adjust the distance between the display module and
the door panel.
– The gasket dimensions are 25 mm (L) x 12 mm (W) x 2 mm (H) and the
center aperture is 6 mm.
Install the new display module in the original position by performing the
preceding steps in reverse order.
Connect the control signal cable to the display module
Copyright © Huawei Digital Power Technologies Co., Ltd.
10 Parts Replacement
134