FusionCol8000-C210 In-room Chilled Water Smart
Cooling Product
User Manual (2022, Netherland GS)
Figure 4-31 Connecting communications cables
----End
4.7 Connecting the Cable for the Water Valve Actuator
Context
●
●
Procedure
Step 1 Route the cables of the water valve actuator through the hole on the unit
according to the route shown in the figure.
Step 2 Connect the cables of the water valve actuator to the specified ports of the unit
based on the mapping.
Issue 01 (2022-12-30)
The installation position of the water valve actuator depends on site
requirements. This section describes only the cable connection method and
route.
Before connecting cables, ensure that the water valve actuator is correctly
installed and is less than or equal to 2 m away from the unit. Ensure that the
arrow on the water valve actuator points to the water flow direction.
Copyright © Huawei Digital Power Technologies Co., Ltd.
4 System Installation
64