Table of Contents
Advertisement
5
The contents of items
Select the contract name to be referenced by pull-down menu and load it using the [Load] button.
Sets the number of display digits after the decimal point. (Calculation is performed at this setting.)
●
Number of digits after the decimal point which is displayed. Select by pull-down menu. (0 to 5)
●
Method of rounding of fractions below the display. Select by pull-down menu. (Round off, count frac-
tions as one, truncate)
Tax calculation setting. Enabled when checkbox is checked.
Input the tax rate at the text box. (0~99.99)
Selects whether the amount of the calculated result is to be handle "Tax inclusive" or "tax exclusive".
When the billed amount includes the tax, select "Tax inclusive" and when the tax is separate, select "Tax
exclusive".
Nighttime charge setting. Set when the electricity charge unit price is different in the daytime and at
nighttime.
Enabled when checkbox is checked.
Set the start time and end time of the time frame corresponding to nighttime charge. (Set in 30 minutes
units and evening of current day to morning of next day)
Weekend charge setting. Set when the electricity charge unit price is different on weekdays and week-
ends.
Enabled when checkbox is checked.
Select the day of week corresponding to weekend charge. (Multiple days can be selected)
Configure the unit price for each item. This is only enabled in the case that usage of the meter was
selected in .
Basic charge setting. Enabled when checkbox is checked.
"Name": An arbitrary name can be set. (Within 20 characters of alphabet, numeric, and symbol)
"Charge": Inputs the basic charge. (Numeric only within 11 digits. Can be changed during calculation)
*
Input up to the number of digits after the decimal point set at
"Divide": Select the charge distribution method by pull-down menu. (Equal distribution, distribution
according to number of units, distribution by amount of electricity used, distribution according to total
indoor unit capacity)
Additional charge setting. Up to 3 additional charges can be set. Enabled when checkbox is checked.
Perform input sequentially, beginning from additional charge 1.
"Name": An arbitrary name can be set. (Within 20 characters of alphabet, numeric, and symbol)
"Charge": Inputs the additional charge. (Numeric only within 11 digits. Can be changed during calcula-
tion)
*
Input up to the number of digits after the decimal point set at
"Divide": Select the additional charge distribution method by pull-down menu. (Equal distribution, distri-
bution according to number of units, distribution by amount of electricity used, distribution according to
total indoor unit capacity)
When checked and [OK] is clicked, items
[OK]:
Saves the edited contents and ends setting.
[Cancel]:
Ends setting without saving the edited contents.
Note
At contract addition, change or end, finish setting up to the relevant date.
If changes are made later, correct calculation will not be performed.
You cannot calculate the start day of data collection.
Do not add/remove outdoor/indoor unit during contract period.
IF you need to do so, end the contract and define a new contract.
Set Basic Charge to the basic amount charged by the electricity company, if there is a basic charge.
If there is no basic charge, you do not need to set this.
Copyright© 2013-2015 Fujitsu General Limited. All rights reserved.
to
can be used in contracts which have already been set.
to
260
.
.
are made the same setting for all the contracts.
Advertisement
Table of Contents
