Table of Contents
Advertisement
9.
Error E-mail Notification Setting
Automatically sends an error notification e-mail to the preset e-mail address whenever an error occurs.
9-1
E-mail Setting screen
To display this screen, select the main screen menu → "Setting" → "Mail setting"
Enters the receiver's name and E-mail address. (Up to 100 names and addresses can be registered)
"No.":Line numbers from 1 to 100 are displayed.
"Effective": When checked, enables setting of that line.
*
When "Effective" is unchecked, an e-mail is not sent.
"Name": Enters the receiver's name. (Within 20 characters of alphabet, numeric, and symbol)
"Address": Enters the receiver's e-mail address.
(Within 50 characters of alphabet, numeric, and symbol)
Enters the SMTP server name for e-mail transmission.
(Within 50 characters of alphabet, numeric, and symbol)
*
The SMTP service name differs with the network environment. If the SMTP server name is unknown, check with
the network administrator.
Enters the sender's e-mail address. (Within 50 characters of alphabet, numeric, and symbol)
Press [Setting] button to change to Out going mail server setting screen.
5
Closes the E-mail Setting screen after setting is complete.
[OK]:
Saves the edited contents and ends setting.
[Cancel]:
Ends setting without saving the edited contents.
[Delete]:
Delete the selected item.
[Transmission Test]: Sends test by email. (Confirm that the email reached its destination.)
Note
Error E-mail transmission conditions
Errors are checked at 5 minute intervals and only errors being generated are sent.
However, errors that were sent and errors which were reset within 5 minutes are not sent.
Copyright© 2013-2015 Fujitsu General Limited. All rights reserved.
5
106
Advertisement
Table of Contents
