Table of Contents
Advertisement
17-2
Detail operation
Indoor unit detail operation control is performed. To display this screen:
●
R/C group selection and right click menu →[Detail]
●
R/C group selection and control pad →[Detail]
●
R/C group selection and main screen menu → "Operation" → "Operation Setting"
575555
Basic operation
Description of Operation Setting screen
At display, the current operation status of the selected R/C group is displayed.
When multiple R/C groups are selected, if the displayed details of each item are "Mixed", they will be dis-
played in a mixed way.
Pattern operation setting
On/Off
Operation start/operation stop
Operation Mode
Operation mode switching
Auto/Cool/Dry/Fan/Heat
*
There are other indoor unit operation status and operation modes which cannot be set depending on the
System Type. For details, see "About operation mode".
Set Temp
Temperature setting
Set by direct numeric input or [v] and [
With the S Series and V Series, setting in 1 degree increments is possible.
With the V-II/V-III/VR-II/J-II/J-IIS Series setting in 0.5 degree increments is possible.
*
When upper and lower temperature limits were set; temperature setting is possible only within that set range.
→ See par. 17-2-2 Extended operation (upper/lower temperature limits setting item)
Copyright© 2013-2015 Fujitsu General Limited. All rights reserved.
Standard display state
] buttons.
Λ
165
Switch to extended display by
[s] button
Message area
Reset/send/close
Advertisement
Table of Contents
