Table of Contents
Advertisement
VRF network list: Sets the scan targets.
Selects the name of the adaptor which is to perform scanning.
(Name set at par. 8-3-2 Transmission adaptor setting.)
Unit registration is necessary for each adaptor.
Adaptor Name
When an adapter is set at a blank line, a blank line is added below it.
The same adapter can be set on multiple lines and different refrigerant system can also be
specified.
Specifies by checkbox whether or not secure registration is to be performed when scanning
Checked: Secure registration (Recommended) Not checked: No secure registration
Secure Reg.
When scanning is performed at secure registration, operation of the units is stopped.
When you do not want to stop operation, uncheck the checkbox.
See par. 31-1 No.6.
Start
Ref. No.
End
Name
Status
Device
Check
Select the "Perform scan for electricity meter".
Put a check also in those adaptors connecting the electricity meters you want to scan.
Not displayed when neither the Electricity Charge Apportionment function nor the Energy Saving op-
tion is not provided.
[Start] button:
Starts scanning. (Disabled when there is no scanning target.)
Note) All systems connected to 1 Transmission adaptor (U10 USB Network Interface) are stopped
during scanning at secure reg.
The time required by scanning differs with the size of the system. Use the indicator displayed at (b)
during scanning as a guideline.
While scanning is being performed, the [Stop] button (c) is displayed. To stop scanning, click this but-
ton.
VRF network list display during scanning
Copyright© 2013-2015 Fujitsu General Limited. All rights reserved.
When partially scanning, specify the start number of the refrigerant system by pull-
down menu or key input. See par.31-1 No.10.
When partially scanning, specify the end number of the refrigerant system by pull-
down menu or key input.
Displays the name of the device used by the relevant network.
Displays the status of the device used by the relevant network.
Normal: "Ready" Abnormal: "Error" Not connected: "Blank"
When the (a) [Wink] button is clicked, the SVC lamp of the Transmission adaptor
used by the relevant network lights (for approx. 2 second) and connection of the se-
lected adaptor can be identified. (Effective only when the status of the Transmission
adaptor is normal.)
(b)
95
(c)
Advertisement
Table of Contents
