85555
Unit name registration
Allocates unit names to the R/C group of indoor unit and outdoor unit group registered by scanning so that
the user can easily identify units.
(Names allocated automatically can also be used.)
Unit name registration options
When unit adaptor name, address, and name given to it
have been decided in advance; input them all at the same
time.
When scanning by System Controller Lite, use the allocated
default name as is.
At automatic allocation in the order of indoor unit operation, assign serial numbers to the units in the order
in which the units are operated.
Note
When automatic allocation in the order of indoor unit operation was performed, register the relationship
between unit and serial No.. After automatic allocation in the order of indoor unit operation is finished,
change the names based on that registration to names by which the units can be easily identified.
Copyright© 2013-2015 Fujitsu General Limited. All rights reserved.
Unit name allocated at scanning (default name)
Automatic allocation in the order of indoor unit operation
Select all adaptors
Operate R/C in sequence
Set start name + serial
No. at all systems
(Indoor unit only)
Change to an easily identifiable name
97
Set adaptors individually
Select all
refrigerant systems
Set start name + serial
No. for each adaptor
(Indoor unit only)
Select refrigerant sys-
tems individually
Start name + serial No.
for each refrigerant
system (Indoor unit only)