27-3
Basic Setting
Sets whether or not outdoor unit standby power is apportioned to non-communicating indoor units.
Set whether or not the outdoor unit standby power is to be apportioned to non-communicating indoor
units.
●
Apportion to non-communicating indoor units
Standby power is apportioned even to non-communicating indoor units
●
Do not apportion to non-communicating indoor units.(apportion to undefined block instead)
Outdoor unit standby power is not apportioned to non-communicating indoor units.
(Standby power not apportioned to non-communicating indoor units is apportioned to the owner block
(Undefined Block).)
Set the apportioning method of RB unit.
●
"Do not calculate RB Unit's power consumption."
The calculation of RB unit is not performed.
●
"Calculate RB Unit's power consumption."
The calculation of RB unit is performed.
[OK]:
Saves the edited contents and ends setting.
[Cancel]:
Ends setting without saving the edited contents.
Note
When System Controller Lite and outdoor unit cannot communicate due to tripping of a unit power break-
er or a network error, since the minimum data needed for apportionment calculation cannot be acquired,
electricity charge apportionment calculation is not performed.
Copyright© 2013-2015 Fujitsu General Limited. All rights reserved.
252