Table of Contents
Advertisement
This screen sets the IP address allocated at incoming connection.Select "Specify TCP/IP address"
and sets the "From" and "To" IP addresses serially to match the installation environment in accor-
dance with the network administrator's instructions.
Normally IP addresses are specified serially, beginning from 192.168. . , but when connecting the
personal computer which performs the setting to another network (for instance, LAN), be sure that the
set IP addresses do not duplicate those of a personal computer on the other network.
For incoming connection, the IP address specified by "From" becomes the IP address of this machine
and the IP address specified by "To" is set at the client IP address. The example below shows setting
when the local personal computer is made 192. 168. 100. 100 and the client IP address is set to 192.
168. 100. 101.
Close the screen by clicking [OK].
Then click [Allow access] in the screen.
Click [Close].
●
Close the "Network Connections" screen.
●
Close the "Network and Sharing center".
Copyright© 2013-2015 Fujitsu General Limited. All rights reserved.
56
Advertisement
Table of Contents
