Table of Contents
Advertisement
85555
Transmission adaptor setting
Sets the name and confirms the connection state of the Transmission adaptor (U10 USB Network Interface)
that connects the VRF Controller.
To display this screen, select main screen menu → "Setting"→ "Initial Setting" → "Adaptor setting".
The adaptor name can be set for easy identification by the user. Click the adaptor name you want to
set and enter the text. (Default name: "AdaptorX")
Up to 20 characters (alphabet, numeric, and symbol) can be set. The adaptor name cannot be dupli-
cated. Only the connected adaptor can be set.
Usable device setting and confirmation are possible.
Name
A usable devices list (LONx) or "Not Used" can be pulled down and selected.
Displays the device status.
Ready
Status
Busy
Error
(Blank)
When the [Wink] button is clicked, the SVC lamp of the speci-
fied device lights (for approx. 2 second) and you can confirm
Check
which Transmission line the adaptor is connected to. (Only
when the device status is Ready)
[OK]:
Saves the settings and ends setting work. (At initial starting, [Back]: Returns to site name
setting)
[Cancel]: Ends setting work without saving the settings. (At initial starting, [Next]: Advances to unit
registration)
Note
Adaptor Name is a name which can be arbitrarily set so that the user can easily identify connection of the
Transmission adaptor (U10 USB Network Interface). (Default name: "AdaptorX")
"Device Name" is a name automatically allocated to the network when a "Transmission adaptor" (U10
USB Network Interface) is connected. (User may select the LONx number)
It is necessity that set Transmission adaptor respectively because of the S/V series and V-II/V-III/VR-II/J-II/
J-IIS series can not be connected to the same communication line.
To perform setting at initial starting, advance to par. 8-3-3 Unit registration by clicking the [Next] button.
If it is changed to "Not Used", all data on the connected adaptor will be deleted.
Copyright© 2013-2015 Fujitsu General Limited. All rights reserved.
The specified adaptor can be used.
The specified adaptor is being used by another system.
The specified adaptor cannot be used.
Not displayed when an adaptor is not connected.
93
SVC Lamp
Advertisement
Table of Contents
