Table of Contents
Advertisement
575755
Common block setting
Sets the block with Common Block
To display this screen, click the
Sets the method the power consumed by common blocks is apportioned to tenant blocks.
Description of screen
Confirms the contract name and block name.
Displays the block name and period of tenant blocks in the same contract as a common block in a list.
Selects the apportionment method by pull-down menu. See the block apportioned at
"Equally": Apportion equally to the selected blocks
"Unit quantity": Apportion by proportion of number of units
"Usage": Apportion by proportion of amount of power
used (metering) (Recommended)
"Capacity": Apportion by allowable capacity of unit
"Manually":
Apportion by arbitrary setting.—— Manual setting of apportionment ratio. In the initial state at
selection, 100% of the consumed power is apportioned to "Undefine" blocks as imaginary
blocks and displayed. Since key input is possible at field (4), adjust so that the total appor-
tionment ratio to the tenant block is 100%. If an apportionment ratio to an "Undefine" block
remains, the "Undefine" block will be charged at apportionment calculation.
5
[OK]:
Saves the setting and ends it.
[Cancel]:
Ends the setting without saving it.
Note
After all settings are finished, electricity charge apportionment data acquisition is started. Close the
"Electricity Charge Apportionment" screen (par. 27-2). When performing electricity charge apportionment
calculation, see par. 28. Electricity charge apportionment.
Copyright© 2013-2015 Fujitsu General Limited. All rights reserved.
checked at par. 27-7-2 Specify Block screen.
Common block [setting] button of par. 27-7-1 Block schedule setting.
267
5
.
Set by checkbox.
Advertisement
Table of Contents
