Lasing Trigger Input: Continuous Trigger - Panasonic VL-W1-N Series Setup And Maintenance Manual

4-6-4 Lasing trigger input: Continuous trigger

When the trigger mode is set to "continuous trigger" in the file option screen, lasing operation is repeated while TRIGGER
IN (X6) is on.
READY OUT (Y6)
TRIGGER IN (X6)
LASING OUT (Y7)
Lasing operation
LASING END OUT (Y8)
WARNING OUT (Y12)
ALARM OUT (Y13)
*1 : If TRIGGER IN (X6) is still ON at the completion of the lasing operation, the lasing operation starts again.
*2 : If TRIGGER IN (X6) turns OFF when the lasing operation is running, the lasing operation is terminated after finishing
the running operation.
Item Time
T1 10 ms or more
T2 0 to 5000 ms
T3 Around 10ms to
100 ms
T4 0.0 to 60.0 sec.
T5 20 to 510 ms
T6 20 to 510 ms
ON
OFF
ON
OFF
ON
T2
OFF
T3 + T4
ON
OFF
ON
OFF
ON (Normal)
OFF (Error)
ON (Normal)
OFF (Error)
Remarks
Keep the ON status for the duration of repeating the lasing operation.
When the trigger delay time is set in the selected file, lasing operation starts after the delay
time.
There is a certain interval between each lasing operation.
The interval duration is defined by the setting data.
When the scanning interval is set, the next lasing operation starts after a lapse of the
setting period.
This is the output to notify that the lasing operation ended. Even when the lasing operation
is interrupted due to the alarm or warning occurrence, LASING END OUT (Y8) turns ON.
This is One-shot output. Set the output time on the environment setting screen. There is a
small margin of error for the setting value.
READY OUT (Y6) is not turned ON while LASING END OUT (Y8) is ON.
It outputs a warning to notify that an invalid trigger was input when TRIGGER IN (X6) was
input during the lasing operation. This is One-shot output. You can turn this warning off by
the settings.
T1
*1 *1 *2
T3 + T4
ME-VLW1N-SM-1
T2
T5
T6
Interrupt
lasing
T5
115