Communication Conditions For Power Monitoring - Panasonic VL-W1-N Series Setup And Maintenance Manual

„ Connecting to external control devices
• If you connect the laser welding machine to the PC for control, use a commercially available RS-232C straight cable.
• In case of connecting to PLC, a type of the cable (straight or cross) differs depending on a manufacturer or a model.
Please follow the PLC manual.
• To connect RS-232C terminal without using a commercially available RS-232C cable, connect only 3 signals of RxD,
TxD and GND and do not use other signals on the laser welding machine side.
• You may need a signal line connection (loop back line) other than RxD, TxD, or GND on the external control device side
depending on the specifications of the external control device. Read the instruction manual of the external control device
and connect it appropriately.
Connection example
Laser welding machine
RS-232C connector
* The loop back wiring on the external control device side shown in the above figure is just an example. The wiring method
varies depending on the specifications of each external control device. Read the instruction manual of the external
control device and connect it appropriately.

6-2-2 Communication conditions for power monitoring

The communication condition for the power monitoring is fixed. Set the external control device to conform to the following
communication condition.
Item
Synchro system
Communication
Baud rate
Data length
Parity
Stop Bits
Flow control
Check sum
Delimiter
Start code
Reception timer
Terminal No. Signal
2 TxD
3 RxD
5 GND
RS-232C communication conditions
Start-stop method
Communication full-duplex transmission
19200 bps
8bit
Odd
1bit
None
Not applicable
CR
@ (40(HEX))
Timeout monitoring ON (5 sec.)
ME-VLW1N-SM-1
External controller
Signal
Straight cable
RxD
TxD
GND
DCD
DTR
DSR
*
RTS
CTS
Terminal No.
2
3
5
1
4
6
7
8
131