Installation Method - Panasonic VL-W1-N Series Setup And Maintenance Manual

2-3-3 Installation method

• Install the head on a durable and plane parallel plate which is made of aluminum or other material with radiation
performance equivalent to that of aluminum.
• For details of installation, refer to "1-5-1 Head" (P.26).
• Fix the head in the following conditions.
Item
Fixing position
Fixing screw
Material of fixing screw
Screw insert length
Tightening torque
Recommended base thickness
• To reduce the influence of galvanic corrosion in the screw section, it is recommended to use stainless steel as the
material for fixing screws.
• Do not insert any screw of length exceeding the specification. Otherwise, the failure of the product may be caused.
M6 screw
„ Example of head installation base
Example dimensions of plate for the head are indicated below.
For plate thickness of 10 mm
Unit: mm
94
80
No. Description
Head fixing hole (six holes): φ6.6 through hole
q
Head positioning pin (2 pins): φ4, SUS pin, height 5
w
• As the laser pointer radiate the beam toward the center of the working field, it is recommended to process the laser
emission port and laser pointer emission port hole to link them so that the laser pointer's beam path does not interfere
with the plate.
44
Model
VL-W1500-N, VL-W1A00-N, VL-W1506-N, VL-W1A06-N
Bottom surface (laser emission port side)
M6 screws at 6 positions
Stainless steel
5 mm to 6 mm
3.0 N·m or below
10 mm to 15 mm
10
20
60
q
80
ME-VLW1N-SM-1
Laser welding machine
Installation plate
A : Screw insert length 5mm to 6mm
B : Plate thickness + washer thickness
5 60
w
On the laser welding machine side
A
B
M6 screw
60