Controller Installation - Panasonic VL-W1-N Series Setup And Maintenance Manual

2-4 Controller Installation

WARNING
„ Carrying the controller
To carry the controller, hold the bottom of the unit with both hands.
Do not hold the fiber unit, cables or connectors at carrying this product.
„ Installation method
• The controller may be installed vertically or horizontally.
• The rubber feet are attached to the bottom of the controller on shipping. Remove the rubber feet in case of fixing the
bottom of the controller directly to the installation place.
• The rubber feet can be mounted either on left or right side face. The attaching location of the controller is symmetrical
for the face.
• For details of installation, refer to "1-5-3 Controller" (P.28).
• Fix the controller in the following conditions.
Fixing surface
Bottom
Side (both left and right side)
M5 screw
• Do not insert any screw of length exceeding the specification. Otherwise, the failure of the product may be caused.
• Do not install the laser welding machine at a place where vibrations and shocks can be directly transmitted to it. In any
environment where effects of vibration are concerned, take measures against vibration on the product, e.g. fitting rubber
feet.
• Make sure that the power is turned OFF at installing. Failure to do so may cause
electrical shock.
• Carry the controller unit with two persons. Lifting or carrying without assistance
may cause of injury.
• To carry this product, wear the non-slip gloves and safety shoes.
• In case it falls down, it may cause injury.
Fixing screw
M5 screws at 4 positions
ME-VLW1N-SM-1
Screw insert length
4 mm to 6 mm
M5 screw
Tightening torque
2.0 N·m or below
M5 screw
53