Panasonic VL-W1-N Series Setup And Maintenance Manual page 79

5.
When DIP switch No. 5 is OFF, select the remote mode state at
powered ON with DIP switch No. 6.
DIP switch No. 6
ON
OFF (initial setting)
• When DIP switch No. 5 is ON, keep DIP switch No. 6 OFF.
• When DIP switch No. 6 is ON, "X5: REMOTE IN" signal on I/O terminal is not available.
WARNING
6.
Install the DIP switch cover to the controller.
• A plastic cover is installed on the DIP switch. Install this cover always to avoid the dust penetration to the controller.
7.
Turn ON the power of laser welding machine.
Remote mode state at powered ON
Starts up with remote mode ON
Starts up with remote mode OFF
• If the DIP switch No. 5 or No. 6 is set to on, construct a manual resetting
system to re-pump the laser when the laser pumping is turned to off due to an
emergency stop or an interlock.
ME-VLW1N-SM-1
79