Husqvarna DXR 95 Operator's Manual page 108

c) Cut the plastic cover from the new grease
cartridge.
d) Install a new grease cartridge in the breaker
grease pump.
e) Bleed the breaker grease pump if no grease
comes from the new grease cartridge. Refer to
To bleed the breaker grease pump (DXR 145,
DXR 275, DXR 305, DXR 315) on page 110 .
To do a check of the quantity of grease
in the grease cartridge in the breaker
grease pump (DXR 275, DXR 305,
DXR 315)
1. Park the product on level ground and stop the
To stop the product (DXR 275,
product. Refer to
DXR 305, DXR 315) on page 84 .
2. Examine the quantity of grease in the grease
cartridge. The grease cartridge is empty when the
plastic sleeve is at the end stop.
108
3. If the grease cartridge is empty, do the procedure
that follows.
a) Clean the area around the grease cartridge
and the breaker grease pump. This prevents
contamination of the breaker grease pump
system.
b) Remove the grease cartridge from the breaker
grease pump.
c) Cut the plastic cover from the new grease
cartridge.
d) Install a new grease cartridge in the breaker
grease pump.
e) Bleed the breaker grease pump if no grease
comes from the new grease cartridge. Refer to
To bleed the breaker grease pump (DXR 145,
DXR 275, DXR 305, DXR 315) on page 110 .
To bleed the breaker grease pump
(DXR 95)
1. Remove the 2 bolts (A) and the left tower cover (B).
B
A
2. Fill the breaker grease pump until the grease piston
is 4 cm above the support. Refer to
of the quantity of grease in the breaker grease pump
(DXR 95) on page 106 .
A
A
To do a check
1401 - 005 - 11.01.2024