Husqvarna DXR 95 Operator's Manual page 47

start. If the airflow blows too much dust at the tool, lower
the airflow.
D
B
Remote control
The product is operated with a remote control.
The remote control can operate by radio signal
transmission. If there is an interference in the
transmission, the frequency changes automatically. A
pairing operation between the product and the remote
control is done by the factory. A new pairing operation
is necessary if the remote control is replaced or if you
change remote controls between products. Refer to
do a pairing operation between the remote control and
the product (DXR 95) on page 75 and To do a pairing
operation between the remote control and the product
(DXR 145) on page 76 and To do a pairing operation
between the remote control and the product (DXR 275,
DXR 305, DXR 315) on page 78 .
The remote control can also operate with a CAN bus
cable connected between the remote control and the
product. For instructions on how to connect the remote
control to the product with a cable, refer to
the remote control to the product with a CAN bus cable
(DXR 95) on page 79 and To connect the remote
control to the product with a CAN bus cable (DXR 145)
on page 79 and To connect the remote control to the
product with a CAN bus cable (DXR 275, DXR 305,
DXR 315) on page 80 . The CAN bus cable that comes
with the product is 10 m.
The remote control has all controls that are necessary
to operate the product. The remote control has a digital
display with a menu system. Refer to
page 48 .
Home view
The display has 2 home views. There is 1 home view
for when the motor is off. Refer to
control on page 73 . The other home view is for when
the motor is on. Refer to
1401 - 005 - 11.01.2024
F
C
E
A
To connect
Menu system on
To start the remote
To start the product (DXR 95)
on page 70 and To start the product (DXR 145) on
page 71 and To start the product (DXR 275, DXR 305,
DXR 315) on page 72 .
The symbols in the quick action bar changes if the motor
is off or on.
Home view, motor off
Position Description
1 Quick action to select the pattern test
mode. Refer to
page 66 .
Home view, motor on
To
Position Description
1 Quick action to select the tool in operation.
2 Quick action to see the product status.
3 Quick action to set the water and the
grease level.
4 Quick action to change language or to see
the faults. The symbol will change if the
product finds a warning or an error.
1
12345 H XX BAR
"Pattern test mode" on
1
12345 H XX BAR
4
2
3
47