Husqvarna DXR 95 Operator's Manual page 92

1. Start the product. Refer to
145) on page 71 .
2. Extend the arm system until the arm system touches
the ground with minimum pressure. The hydraulic
pressure in the hydraulic cylinders is released.
3. Extend the outriggers until the outriggers touches
the ground with minimum pressure. The hydraulic
pressure in the hydraulic cylinders is released. Refer
To operate the outriggers on page 83 .
to
4. Stop the product. Refer to
145) on page 83 .
5. Remove the 4 screws and the front cover.
6. Clean the area around the air filter.
92
To start the product (DXR
To stop the product (DXR
7. Remove the air filter to release the hydraulic
pressure in the hydraulic oil tank.
8. Wait 5 minutes for the hydraulic pressure to
decrease through internal leakage.
9. Install the air filter on the hydraulic oil tank.
10. Install the front cover and tighten the 4 screws.
For the caterpillar track unit, release the hydraulic
pressure in the hydraulic accumulator. Refer to
remove and install the caterpillar tracks (DXR 145) on
page 121 .
To release the hydraulic pressure in the
hydraulic system (DXR 275, DXR 305,
DXR 315)
WARNING:
equipment when you release the pressure
in the hydraulic system. Refer to
protective equipment on page 25 .
1. Start the product. Refer to
275, DXR 305, DXR 315) on page 72 .
2. Extend the arm system until the arm system touches
the ground with minimum pressure. The hydraulic
pressure in the hydraulic cylinders is released.
3. Extend the outriggers until the outriggers touches
the ground with minimum pressure. The hydraulic
pressure in the hydraulic cylinders is released. Refer
To operate the outriggers on page 83 .
to
4. Stop the product. Refer to
275, DXR 305, DXR 315) on page 84 .
5. Open the left hatch on the product.
To
Use personal protective
Personal
To start the product (DXR
To stop the product (DXR
1401 - 005 - 11.01.2024