Husqvarna DXR 95 Operator's Manual page 42

d) Lift the arm system and fully retract cylinder 4 to
align the rear holes on the tool hitch (G) with the
rear holes on the tool (H).
G
H
e) Install the rear axle (I) and lock it with the lock pin
(J).
7. Connect the hoses from the tool to the product. Do
the procedure that follows:
a) Connect the return hose (K) to the A port (L) on
the right side of the product.
L
K
42
I
J
b) Connect the pressure hose (M) to the B port (N)
on the left side of the product.
8. Remove the tool in the opposite sequence.
To install and remove the tools on the
product (DXR 145, DXR 275, DXR 305,
DXR 315)
If a tool is not installed on the product, the hoses on the
tool must always be connected together.
WARNING:
correctly and safely installed. The tool can
cause serious injury if it falls off the product.
WARNING:
in the work area when you change the tool.
Prevent accidental start of the product while
you change the tool and make sure that you
can quickly stop the product. Keep hands
and feet away from areas where there is a
risk of crush injury.
1. Remove dirt from the hydraulic couplings on the
product.
2. Start the product. Refer to
145) on page 71 and To start the product (DXR
275, DXR 305, DXR 315) on page 72 .
3. Put the product on a stable surface.
4. Extend the outriggers. Refer to
outriggers on page 83 .
5. Put the tool in front of the product. The holder on the
tool must point at the product.
6. Make sure that the tool is in correct position. Do the
procedure that follows. The tool is seen from the rear
side.
N
M
Make sure that the tool is
It can be necessary to be
To start the product (DXR
To operate the
1401 - 005 - 11.01.2024