Husqvarna DXR 95 Operator's Manual page 79

Table of Contents

Advertisement

Available languages

Available languages

13. Push the right side button when the serial numbers
agree. A message on the information center display
will show for 2 seconds that the pairing operation is
done.
14. Stop the product to restart the radio communication
To stop the product (DXR 275,
receiver. Refer to
DXR 305, DXR 315) on page 84 .
15. Restart the remote control. Refer to
remote control on page 73 .
16. Start the product. Refer to
275, DXR 305, DXR 315) on page 72 .
17. Make sure that there is a radio signal symbol in
the information center display. Refer to
center display on page 68 .
18. Install the left side cover and close the left hatch on
the product.
To operate the product with the remote
control connected with a CAN bus
cable
WARNING:
control connected with a CAN bus cable
where there is a risk that the product can
fall.
Note:
It is necessary to do a pairing operation by radio
before you use the remote control with a CAN bus cable.
The radio signal transmission stops when the remote
control is connected with the CAN bus cable.
1. Remove the batteries from the remote control.
2. Connect the CAN bus cable between the remote
control and the product. Refer to
remote control to the product with a CAN bus cable
(DXR 95) on page 79 and To connect the remote
control to the product with a CAN bus cable (DXR
145) on page 79 and To connect the remote control
to the product with a CAN bus cable (DXR 275, DXR
305, DXR 315) on page 80 .
To connect the remote control to the product
with a CAN bus cable (DXR 95)
1. Remove the remote control batteries from the
remote control.
1401 - 005 - 11.01.2024
To start the
To start the product (DXR
Information
Do not use the remote
To connect the
2. Put one end of the CAN bus cable in the connector
on the remote control.
3. Put the other end of the CAN bus cable in the
connector on the product.
4. Tighten the connector screws for the CAN bus cable
by hand.
To connect the remote control to the product
with a CAN bus cable (DXR 145)
1. Remove the remote control batteries from the
remote control.
79

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dxr 145Dxr 275Dxr 305Dxr 315

Table of Contents