Husqvarna DXR 95 Operator's Manual page 73

7. Turn the machine stop button (B) clockwise to
disengage the machine stop.
D
C
F
8. If more than one product with remote control is used
in the same workplace, do this procedure to make
sure that you have the correct remote control:
a) Turn the OFF/ON/START switch to the ON
position (C) to start the remote control.
b) Push and hold the headlights button (D) until the
connected product flashes.
WARNING:
motor before you know which
product that is connected.
9. Turn the OFF/ON/START switch to the START
position to start the motor. You will hear that the
product is on and the indicator light for operation
comes on.
10. In the display (E), make sure that the radio signal
or cable connection symbol is shown. The symbols
show that the connection between the remote control
and the product is in operation.
Note:
An error message shows in the display if
there is a fault. Refer to
page 131 .
11. Push the operation mode switch (F) up to select
work mode. Push the operation mode switch down
to select transport mode. Refer to
on page 81 .
To start the remote control
The remote control can be on with the motor off. The
display shows how the product can operate when you
use the joysticks as if the motor was on. The test
1401 - 005 - 11.01.2024
E
B
Do not start the
Messages on the display on
Operation modes
operation is done in the pattern test mode. Refer to
"Pattern test mode" on page 66 .
1. Turn the machine stop button (A) clockwise to
disengage the machine stop.
B
2. Turn the OFF/ON/START switch to the ON position
(B) to start the remote control. The display shows the
home view for when the motor is off. Refer to
view on page 47 .
To lock and unlock the remote control
• To lock or unlock the remote control, quickly push
the lock button (A) and enter the PIN code. The PIN
code from the factory is "123412".
A
Home
A
73