Husqvarna DXR 95 Operator's Manual page 28

• Do not short circuit the battery charger.
• The battery charger must be externally fused with
3.0 A fuse.
• Disconnect the battery charger from the power
supply when it is not in being used.
• Do not use the battery charger at temperatures
higher than 45°C.
• The battery charger must only be supplied at SELV
(Safety Extra-Low Voltage) corresponding to the
marking on the battery charger.
• The connection to the power supply must be in
accordance with the national wiring rules.
Operation safety
WARNING:
instructions that follow before you use the
product.
• Make sure that you know which side of the product is
the front and which is the rear. Refer to the forward
direction marks on the side of the caterpillar tracks to
prevent incorrect operation.
• Make sure that the arm system is retracted when the
outriggers are retracted. This decreases the risk that
the product overturns.
• During operation with a breaker or a bucket, the
weight of the product is used to increase the force
on the work object. This can cause the outriggers
to come off the ground. Do not let the outriggers
come off the ground more than necessary. When the
outriggers come off from the ground, there is a risk
that the product tilts, and the load on the remaining
support mechanism increases.
• In some small spaces it is not possible to extend
the outriggers. If the outriggers are not extended,
adapt your operation. There is an increased risk that
the product falls when the arm system moves if the
outriggers are not extended.
• Operation with a breaker can increase the risk that
the product tilts. This can cause the outriggers to hit
the ground with a large force. Make sure that there is
no risk of damage or injury if this occurs.
• Make sure that the outriggers are extended and that
the arm system operates near the ground when the
tower rotates to the side.
• Operate the tower carefully. The direction of rotation
is not easy to know before you start to operate.
• Do not hit the work object with the arm system or the
tower. Use the installed tools only for the operation.
• During operation, make the product as level as
possible and make sure that the outriggers are fully
extended. Do not operate the arm system if the
outriggers are retracted.
• Put the product near the work object to decrease the
load on the arm system. This decreases the risk that
the product falls.
28
Read the warning
• Do not attach the product to walls or other objects
to increase the force on the work object. This can
cause overload on the product and the tool.
• To prevent overload, do not operate the cylinders
in the inner or outer end position. Keep a small
distance to the end positions.
• Do not operate the cylinders to their end positions
when you operate the breaker in an up direction.
This can cause damage to cylinders 1 and 2.
• Do not operate the cylinders to their end positions
when you operate the breaker in a down direction.
This can cause damage to cylinder 3.
• DXR 315: Do not use the telescopic arm to push the
tool against the work object.
• When the operation is completed, lower the arm
system to the ground before you stop the product.
• Restart the product each 24 hours to make sure that
the product operates correctly.
1401 - 005 - 11.01.2024