Husqvarna DXR 95 Operator's Manual page 68

"Remote settings"
• "Brightness" sets the brightness of the display.
• "Language" sets the text language on the display.
The factory setting for language is English.
Note:
To go back to factory setting for language
and brightness, push and hold the home button (A)
for 10 seconds.
A
• "Units" sets the units for pressure and temperature in
the display.
• "Lock remote pincode" sets the PIN code for the
remote control.
"Revisions"
"Revisions" shows the software version and HID number
of the remote control and product.
"Third party licenses"
"Third party licenses" shows the open source licenses
for the operating system and the app licenses in the
remote control. Refer to
159 for more information.
"Factory settings"
"Factory settings" must only be used by an approved
service agent.
68
Third party licences on page
Information center display
A B
C
Information center
The information center display on the remote control
shows the information that follows about the remote
control:
• If the remote control is on or off.
• If the remote control locked or unlocked.
• Fault codes. Refer to
on page 131 .
• Pairing operation between the remote control and
the product. Refer to
between the remote control and the product (DXR
95) on page 75 and To do a pairing operation
between the remote control and the product (DXR
145) on page 76 and To do a pairing operation
between the remote control and the product (DXR
275, DXR 305, DXR 315) on page 78 .
• The radio signal strength (A) between the remote
control and the product. The same symbols are
also shown in the top bar on the display. Refer to
Symbols in the top bar on the display on page 18
Radio signal
There are 4 levels of radio signal
strength.
Radio signal is in standby mode.
The remote control does not oper-
ate correctly. Make sure that all
controls on the remote control are
in the neutral positions when you
start the remote control.
D
Fault codes and descriptions
To do a pairing operation
Symbol
1401 - 005 - 11.01.2024