Husqvarna DXR 95 Operator's Manual page 76

6. Loosen the 5 bolts (D) and remove the rear cover (E)
on the product.
D
D
7. Start the product. Refer to
95) on page 70 .
8. Put a magnet on the bottom side of the radio
communication receiver on the magnet symbol (F)
in 5 s after the start of the product. The indicator (G)
on the radio communication receiver flashes orange
quickly when it waits for a pairing operation to start.
F
Note:
It is necessary to put the magnet on the
magnet symbol in 5s after the start of the product.
After 5s the radio communication receiver cannot do
the pairing operation.
9. Remove the magnet immediately.
76
E
D
To start the product (DXR
G
10. A serial number shows on the information center
display when a radio communication receiver is
found.
11. Make sure that the serial number on the information
display agrees with the serial number on the radio
communicator receiver.
12. If the serial numbers do not agree, the pairing
operation was not done correctly. Do the procedure
that follows.
a) Find the product with the agreed serial number
and turn that product off.
b) Stop your product. Refer to
(DXR 95) on page 83 .
c) Do the pairing operation again.
13. Push the right side button when the serial numbers
agree. A message on the information center display
will show for 2 seconds that the pairing operation is
done.
14. Stop the product to restart the radio communication
To stop the product (DXR 95) on
receiver. Refer to
page 83 .
15. Restart the remote control. Refer to
remote control on page 73 .
16. Start the product. Refer to
95) on page 70 .
17. Make sure that there is a radio signal symbol in
the information center display. Refer to
center display on page 68 .
18. Install the rear cover on the product.
To do a pairing operation between the
remote control and the product (DXR
145)
The pairing operation between the product and the
remote control is done by the factory. A new pairing
operation is necessary if the remote control is replaced
or if you change remote controls between products.
1. Start the remote control. Refer to
control on page 73 .
To stop the product
To start the
To start the product (DXR
Information
To start the remote
1401 - 005 - 11.01.2024