Husqvarna DXR 95 Operator's Manual page 132

Fault code number
3
5
6
7
10
11
12
13
14
16
17
19
20
132
Message in the dis-
play
"Wrong incoming
voltage Phase lost"
"Wrong incoming
voltage Grid frequen-
cy"
"Wrong incoming
voltage Voltage too
low"
"Wrong incoming
voltage Voltage too
high"
"Grid frequency Out
of range"
"Oil temperature
High"
"Oil temperature
Low"
"Oil pressure Too
high"
"Safety Error Idle
valve"
"Hydraulic oil level
Low"
"Oil filter Service nee-
ded"
"Remote control
Communication lost"
"Motor temperature
Too high"
Cause
Incorrect input voltage and phase
loss.
The grid frequency is out of
range.
The input voltage is too low.
The input voltage is too high.
The grid frequency does not
agree with the product frequency
setting.
The oil temperature is too
high. The operation speed is de-
creased and the tool is disabled.
The oil temperature is too
low. The operation speed is de-
creased and the tool is disabled.
The oil pressure is too high.
-
The hydraulic oil level is too low.
The pressure of the hydraulic oil
filter is too high.
Lost communication to the re-
mote control for more than 120s.
The motor temperature is too
high. The operation speed is de-
creased and the tool is disabled.
Solution
Do a check of the input voltage
and the cables.
Do a check of the voltage source.
Do a check of the input voltage
and the cables.
Speak to Husqvarna service.
Operate the product in idle mode
to cool down the oil. Clean the
hydraulic oil cooler and do a
check of the cooling fan.
1. Operate the product in idle
state.
2. Extend the outriggers. First
operate the caterpillar tracks
slowly and the more quickly.
3. Do a check of the settings for
the adjustable temperature
limit.
4. Do a check of the tempera-
ture sensor (T4) and the ca-
bles to the sensor.
5. Make sure that the hydraul-
ic oil grade, ISO VG, agree
with the operation tempera-
Hydraulic oil on
ture. Refer to
page 146 .
Speak to Husqvarna service.
Speak to Husqvarna service.
Fill the hydraulic oil tank with hy-
draulic oil.
Replace the hydraulic oil filter.
Accept the warning message on
the display. The remote control
will try to connect with the prod-
uct.
Operate the product in idle mode.
1401 - 005 - 11.01.2024