Husqvarna DXR 95 Operator's Manual page 26

product. Change the work area if the conditions
change during operation.
Y
X
• Cordon off the work area.
• Increase the work area when you do work at a
height. Cordon off the risk area at ground level.
Make sure that no materials can fall down and cause
injury.
• Keep the work area sufficiently illuminated.
• The product can be operated by a remote control for
long distances. Do not operate the product unless
you have clear view of the product and its risk area.
Use a camera system if the view is not sufficient.
• Clear the work area of obstacles.
• Be careful when there is a risk of slippery surfaces.
• Do a check of the ground conditions and the support
structures to make sure that materials, equipment
and bystanders cannot fall.
• Do not use the product in areas where fire or
explosions can occur.
• Do a check of the work area before operation. Make
marks where there are pipelines, electrical cables,
electrical sources and electrical equipment to avoid
causing damage to them during operation.
• Make sure that there is no flow in the pipelines in
the work area. Make sure that the electrical cables,
electrical sources and electrical equipment in the
work area are disconnected. The product must not
come near power lines in the air.
Electrical safety
WARNING:
shocks from electrical products. Do not use
the product in bad weather conditions, for
example, heavy fog or rain, strong wind and
sand storm. Always use the product as given
in this operator's manual to prevent injury.
26
X Y
There is always a risk of
WARNING:
physiological effect of current flowing
through the body is the effect it can have on
the heart. For this reason service personnel
should be trained in first aid including
cardiopulmonary resuscitation (CPR) and
the use of an automatic external defibrillator
(AED).
• Make sure that the power supply and its fuse and
mains voltage, are the same as the voltage shown
on the rating plate of the product. Refer to
data on page 143 .
• DXR 95 complies with IEC 61000-3-12.
• Keep the power cord away from heat, oil, sharp
edges or moving parts. A damaged power cord
increases the risk of electrical shock.
• Always stop the product before you disconnect the
power plug.
• Do not use the product if the power cord or power
plug is damaged. Let an approved service center
repair the product. A damaged power cord can
cause serious injury and death.
• Make sure that the power cord does not go
below the product when the product moves or the
outriggers are retracted or extended.
• Use the power cord correctly. Do not use the power
cord to move, pull or disconnect the product. Pull the
power plug to disconnect the power cord. Do not pull
the power cord.
• Do not operate the product in water depths where
the electrical equipment of the product becomes wet.
The electrical equipment can become damaged and
the product can become electrically conductive and
cause injury.
• Do not open the electrical enclosure when
the product is connected to a power source.
Some components in the electrical enclosure are
permanently live.
• Always connect the product with a ground fault
circuit that releases at a ground fault of 30 mA.
• Do not let the hydraulic connections touch soruces
of electricity. The hydraulic connections are not
electrically insulatetd. There is a risk of electric
shock.
Grounded product instructions
WARNING:
result in electrical shock. Speak to an
approved electrician if you are not sure if
your mains outlet is correctly grounded.
Do not do modifications to the power plug
from its factory specification. If the power
plug or power cord is damaged or must be
replaced, speak to your Husqvarna service
agent. Obey local regulations and laws.
The most severe
Technical
Incorrect connection can
1401 - 005 - 11.01.2024