Husqvarna DXR 95 Operator's Manual page 119

• Measure the distance (A). The tension is correct
when the distance (A) is 65–75 mm.
• Adjust the tension in the caterpillar tracks if it
is necessary. Refer to
caterpillar tracks tension (DXR 95) on page 119 .
To manually adjust the caterpillar tracks
tension (DXR 95)
1. Lower the outriggers. Refer to
outriggers on page 83 .
2. Remove the 2 bolts and the inspection door.
1401 - 005 - 11.01.2024
A
To manually adjust the
To operate the
3. Tighten the tension nut (A) to increase the tension in
the caterpillar tracks.
B
CAUTION:
caterpillar tracks. There is a risk of
damage to the motor.
4. Loosen the tension nut to decrease the tension in
the caterpillar tracks.
5. Adjust the tension nut until the distance (A) is 65–
75mm.
6. Install the inspection door and the 2 bolts.
To remove and install the caterpillar tracks
(DXR 95)
1. Start the product. Refer to
95) on page 70 .
2. Park the product on level ground.
3. Fully extend the outriggers. Refer to
outriggers on page 83 .
4. Stop the product. Refer to
95) on page 83 .
Do not over-tighten the
A
To start the product (DXR
To operate the
To stop the product (DXR
A
119