Dell PowerVault MD3620f Command Line Interface Manual page 242

iscsiHostPortOptions
rloginEnabled=(TRUE | FALSE) |
serviceAllowedIndicator=(on | off)
Parameters
Parameter
controller
availability
ethernetPort
globalNVSRAMByte
hostNVSRAMByte
IPv4GatewayIP
242
Script Commands
Description
The RAID controller module for which you want to
define properties. Valid identifiers for the RAID
controller module are 0 or 1, where, 0 is the RAID
controller module in slot 0, and 1 is the RAID
controller module in slot 1. Enclose the identifier
for the RAID controller module in square brackets
([ ]). If you do not specify a RAID controller
module, the firmware for the RAID controller
module returns a syntax error.
The mode for the RAID controller module, which
you can set to online, offline, or serviceMode
(service).
The attributes (options) for the management
Ethernet ports. The entries to support this
parameter are listed in the Syntax Element
Statement Data table that follows. Many settings
are possible, including setting the IP address, the
gateway address, and the subnet mask address.
A portion of the RAID controller module NVSRAM.
Specify the region to be modified using the starting
byte offset within the region and the size and value of
the new data to be stored into the NVSRAM.
The NVSRAM for the host-specific region. The
setting specifies the host index for the specific
host, the starting offset within the region, the
number of bytes, and the values to be written.
The IP address of the node that provides the interface
to the network. The address format for the IPv4
gateway is (0–255).(0–255).(0–255).(0–255).