Set Storage Array Learn Cycle - Dell PowerVault MD3620f Command Line Interface Manual

Set Storage Array Learn Cycle

This command sets the learn cycle for the battery backup unit. The learn
cycle enables the MD storage management software to predict the remaining
battery life. Learn cycles run at set intervals and store the results for
software analysis.
Syntax
set storageArray learnCycleDate
(daysToNextLearnCycle=numberOfDays |
day=dayOfTheWeek) time=HH:MM
Parameters
Parameter
daysToNextLearnCycle Valid values are 0 through 7, where, 0 is immediately
day
time
NOTE:
You can set the learn cycle to occur only once during a seven-day period.
The time parameter selects a specific time that you want to run the learn cycle. If a
value is not entered, the command uses a default value of 00:00 (midnight). If the
day and time specified are in the past, the next learn cycle takes place on the next
possible day specified.
Description
and 7 is in seven days. The daysToNextLearnCycle
parameter takes place up to seven days after the next
scheduled learn cycle.
Valid values for the day parameter include the days of
the week. Setting the day causes the next learn cycle
to be scheduled on the specified day, after the
currently scheduled learn cycle.
The time in 24-hour format; for example 8:00 a.m. is
entered as 08:00. Nine o'clock p.m. is entered as
21:00, and 9:30 p.m. is entered as 21:30.
Script Commands
259