Set Storagearray Enclosurepositions - Dell PowerVault MD3620f Command Line Interface Manual

Set Storage Array Enclosure Positions
This command defines the position of the enclosures in a storage array. You
must include all of the enclosures in the storage array when you enter
this command.
Syntax
set storageArray enclosurePositions=(controller |
enclosureID... enclosureIDn)
Parameter
Parameter
enclosurePostions
Additional Information
This command defines the position of an enclosure in a storage array by the
position of the enclosure ID in the enclosurePositions list. For example, if you
have a RAI enclosure with an ID set to 84 and expansion enclosures with IDs
set to 1, 12, and 50, the enclosurePositions sequence (84 1 12 50) places the
RAID enclosure in the first position, expansion enclosure 1 in the second
position, expansion enclosure 12 in the third position, and expansion
enclosure 50 in the fourth position. The enclosurePositions sequence (1 84 50
12) places the RAID enclosure in the second position, expansion enclosure 1
in the first position, expansion enclosure 50 in the third position, and
expansion enclosure 12 in the fourth position.
NOTE:
You must include all of the enclosures in the storage array in the list defined
enclosurePositions
by the
not match the total number of enclosures in the storage array, an error message
is shown.
256
Script Commands
Description
A list of all of the enclosure IDs. The sequence of the
enclosure IDs in the list defines the positions for the
RAID enclosure and the expansion enclosures in a
storage array. Valid values are 0 to 99. Enter the
enclosure ID values separated by a space. Enclose the list
of enclosure ID values in parentheses. For storage arrays
where the RAID enclosure has a predefined identifier
that is not in the range of valid enclosure position values,
use the controller value.
parameter. If the number of enclosures in the list does