Set Snapshot Virtual Disk - Dell PowerVault MD3620f Command Line Interface Manual

Additional Information
When you use this command, you can specify one or more of the optional
parameters.
Passwords are stored on each storage array in a management domain. If a
password was not previously set, you do not need a password. The password
can be any combination of alphanumeric characters with a maximum of 30
characters. (You can define a storage array password by using the set
storageArray command.)
The polling interval and the number of iterations that you specify remain in
effect until you end the session. After you end the session, the polling interval
and the number of iterations return to their default values.

Set Snapshot Virtual Disk

This command defines the properties for a snapshot virtual disk and lets you
rename a snapshot virtual disk.
Syntax
set (virtualDisk [virtualDiskName] |
virtualDisks [virtualDiskName1 ...
virtualDiskNameN])
userLabel="snapshotVirtualDiskName"
warningThresholdPercent=percentValue
repositoryFullPolicy=(failSourceWrites |
failSnapshot)
Parameters
Parameter
virtualDisk or
virtualDisks
userLabel
250
Script Commands
Description
The name of the specific snapshot virtual disk for
which you want to define properties. (You can
enter more than one virtual disk name if you use
the virtualDisks parameter). Enclose the
snapshot virtual disk name in double quotation
marks (" ") inside of square brackets ([ ]).
A new name that you want to give to a snapshot
virtual disk. Enclose the new snapshot virtual disk
name in double quotation marks (" ").