Toshiba Strata CTX Programming Manual page 103

F
IELD
15 Ringing Preference
16 Text Message
Display
17 Call History
Memory
18 DTMF Back Tone
19 Continuous DTMF
20 Display Language
21 Adapter
22 Blind Transfer
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
D
ESCRIPTION
Ringing call answer preference.
Possible values: Longest or Call Type (default)
• Longest Ringing - any call type - Calls are answered in order of the longest
ringing line no matter what type of call (FIFO).
• Longest Ringing - by call type priority - Call Type priority is applied to the longest
ringing button.
Call Type Priorities are fixed is software as shown below:
•
Emergency Calls
•
Hands Free Calls (after it is switched to ringing by the caller).
•
ACD calls
• Recalls (Hold recall, Automatic call back, ABR, etc.)
• External Calls (DID, DIT DISA line calls etc.)
•
Internal Calls (station, Attendant, Tie line, door phone, etc.)
Select whether to display an LCD text message. Immediate displays the message.
Not immediate does not display the message.
Possible values: Immediate (default) or Not Immediate
Enter the number of calls to be stored in memory for this station.
Possible values: 0~100 (default = 0)
Enables audible DTMF when dialing from a DKT to a trunk or Voice Mail port.
Padded dialing mutes the volume level to the caller not the called trunk or VM
device.
Possible values: Padded, DTMF Tone (default) or No Tone
Enable / Disable Continuous DTMF for DKT2000 and DTK3000 series telephones.
Enabled allows the telephone to send DTMF tones to the far end continuously as
long as the key on the dial pad is held down.
Notes
•
For each iES32 PDN, set to 'Not Continuous', if set to 'Continuous', outdial
notification to pagers and calls to AMIS nodes will not function properly.
• DKT1000 series telephones do not support continuous DTMF. DKT1000 series
telephones must be set to 'Not Continuous' or they will misdial.
Possible values: Continuous (default) or Not Continuous
Select the LCD Display Language.
Possible values: English (default), British English or French
Select the Adapter Type (Desktop OAI or Attendant Console).
•
BPCI – for USB interface.
• BATI – for PC Attendant Console Interface.
Possible values: None (default), BPCI or BATI
Set Blind Transfer Action (Attendant Type Only).
Possible values: Leave or Separate (default)
Station
Assignment
5-11