Toshiba Strata CTX Programming Manual page 222

Services
Networking
4. Define the remote node port number (12 in the example above). Select System > I/O Device, select the
LAN Device tab. Refer to
following selections:
• 00 LAN Port No. = 12
• 01 Protocol = UDP
• 02 PC Operation Type = Server
• 03 Data Flow = A Synchronization
• 04 Server Port No. = 3000
• 05~08 Client IP 1-4 No. = Default
• 09 Client Port No. = Default
• 10 Read Retry No. = 1
• 11 Write Retry No. = 1
• Select FB01 Protocol to UDP and FB04 Server Port No. to 3000. FB04 is the DSS Server Port. All
other parameter can have defaults.
5. Make sure the Remote Node IP address and Network DSS port Number are consistent. From the
Program Menu, select Services > Networking > Remote Node Data Assignment (Program 670).
6. In Program 670, enter the parameters as follows:
Remote Node ID = 12. (This is a QSIG Node ID. In the example above these Node IDs are 16, 17
and 18.
Remote Node IP Address = IP address of the remote CTX. In the example above the IP addresses are
192.168.1.44, 192.168.1.43 and 192.168.1.53.
Remote Node Port No. = 3000. This port number is the Network DSS port number. The Network DSS
port number can be any available port. All Network DSS ports can also be the same, i.e; 3000 in the
above example.
7. Verify the DSS refresh time in System > System Timer, FB 24. Refer to
page 4-10.
8. Assign the DSS Remote Node feature key using Program 205, 213 and 215. Refer to
page 5-16. DSS button can have up to seven digits, so Node ID can be included. Before R1.3 five digits
were the maximum allowed in a DSS button.
9. From each remote CTX, repeat steps 1~8 to set up Network DSS.
9-36
"801 Network Jack LAN Device Assignment"
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
on page 4-29. Make the
"104 System Timer" on
"Key" on