Program 204 - Toshiba Strata CTX Programming Manual

Telephone Button Programming
Button Programming Examples

Program 204

Reference "Program 204"
enables you to setup the DKT parameters.
1. Enter programming mode. See
2. At the PROG=
3. At the DN=
)%
4. Press
)%
5. Press
For this example, we are using a 20-button DKT. There are three button patterns to choose from for
each type of digital telephone.
Only the above
+ROG
6. Press
Additional assignments can be made to fine tune DKT parameters. See Summary column for field
Note
descriptions and default values. If specific assignments are not made, the system automatically
assigns the default value.
Program 205
Reference "Program 205"
page 13-39. This program assigns features and parameters to the FB buttons on your DKT telephone. In
this example, the
1. Enter programming mode. See
2. At the
PROG=
3. At the DN=
)%
4. Press
To select the n1, n2, n3, n4 and n5 values required in
table titled

5. Enter to assign a GCO number and press

6. Enter to assign a GCO index and press

7. Enter to enable immediate ringing for this GCO and press

8. Enter to assign a soft ring tone to this GCO and press

9. Enter
+ROG
10.Press
Press
Note
Program 208
Reference "Program 208"
1. Enter programming mode. See
2. At the
PROG=
3. At the DN=
)%
4. Press
13-6
on page 13-33
"Step 1: Enter Program Mode

prompt enter and press

prompt enter (n) and press

. Press to select a Extension and press

. Press to select Pattern 3 for this DKT and press
)%
s need to be assigned. Press
to return to the
PROG=
on page 13-37
)%
button on your DKT will be programmed to act as a GCO button.
"Step 1: Enter Program Mode

prompt enter and press

prompt enter (n) and press

. Enter to assign a GCO and press
"Feature/Button Code Parameter Assignments"
to assign an Owner DN to this GCO number and press
to return to the PROG=
+ROG
again to exit Button Programming Mode.
on page 13-44. This program assigns timing parameters to Primary DNs.
"Step 1: Enter Program Mode

prompt enter and press

prompt enter (n) and press

. Press to set the number of ABR attempts and press
and review Summary column field descriptions. This program
on
+ROG
.
+ROG
.
+ROG
.
+ROG
+ROG
again before proceeding to the next step.
prompt.
and "Feature/Button Code Parameter Assignments"
on
+ROG
.
+ROG
.
6SNU
.
"Program 205"
on page
6SNU
.
6SNU
.
6SNU
6SNU
.
prompt.
on
+ROG
.
+ROG
.
Strata CTX Programming - Part 3:Telephone Button Programming 04/03
page 13-7."
.
page 13-7."
on page 13-37, see "GCO" in the
13-39.
.
+ROG
twice.
page 13-7."
+ROG
.
on