Toshiba Strata CTX Programming Manual page 95

F
IELD
10 Call Waiting Tone
11 Dialing Progress
Tone
12 System Call
Forward.
13 Call Pickup
14 Bearer Capability
15 Display DN
16 Caller Emergency
Service Identification
(CESID)
17 Emergency Call
Group
18 Remote CF/DND
Password
19 VMID Code SMDI
22 MW to VM Port
23 Travelling COS
Change
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
D
ESCRIPTION
Select desired waiting tone for Offhook Campon.
Possible values: None (default), Singular or Continuity
Select type of Tone to hear after dialing LCR access code
Possible values: Dial Tone (default), Entry Tone or Silence
Select the System Call Forward Group number.
Possible values: 0~4 (CTX100), 0~10 (CTX670 Basic), 0~32 (CTX670 Exp.),
(default = 0)
The station privilege to activate Call Pickup.
Possible values: Permitted (default), Group Only or Not Permitted
ISDN Bearer Capability the PSTN is expecting from non ISDN stations.
Possible values: 3.1kHzAudio (default) or Speech
Enter the number to be displayed on the calling telephone that rings this PDN
number. This number is will be overridden by Program 209, 04 (if assigned) and if
the PDN is in a hunt group.
Possible values: Up to 5 ASCII characters (default = no value)
Enter the E911 Calling Party Information identifier for this station (CESID).
Possible values: Up to 16 digits (default = no value), however CESID should be 10
digits or less for Centralized Automatic Message Accounting
(CAMA) E911 trunk. PRI E911 allows upto 16 digits.
Enter the Emergency call group that this station belongs to.
Possible values: 1~8 (default = 1)
Enter password to set or cancel DND or station Call Forward from another CTX
station; or, for Call Forward only, from a external DSIA line.
Possible values: Up to 4 ASCII characters (default = no value)
Note DND can not be set/canceled remotely from a DISA line.
Enter the voice mail box number that should answer calls when this PDN calls voice
mail; or, when this PDN is called and then forwards to voice mail (this number is
prefixed by codes in Program 579, 11~16)
Possible values: Digits 0~9, * and #, up to 10 characters (default = no value).
Note This VMID code is sent to the voice mail device in SMDI packets or DTMF
tones on direct calls to voice mail from the PDN; and on calls to the PDN
that forward to voice mail. See Program 580 for SMDI or DTMF choice.
Enter the Message Waiting center DN. For Remote CTXs, assign message center
including Node IP for TPI integration. This parameter enables Call Record function
too.
Possible values: Up to 7 ASCII characters (default = no value)
Enable this station with the privilege to change the Travelling COS Override Code.
Possible values: Enable or Disable (default)
Station
Assignment
5-3