Pri Trunks - Toshiba Strata CTX Programming Manual

302 PRI Trunks

Prerequisite Program:
The PRI Interface card needs to have a number of assignments for defining its operation. These include
which channels are available for use and the location of the D channel or signaling channel. A number of
optional functional capabilities also need to be enabled or disabled.
D Channel exists on the circuit assigned in this command.
Note PRI ILGs and OLGs are assigned using
be set to 0.
1. Complete the
Record Sheet"
2. From the Program Menu, click
Trunk > ISDN > PRI.
3. Enter Channel Group number
...or click one of the following
buttons:
• List – view a summary list of
programmed Trunks.
• Create – Assign a new Trunk
with default settings.
• Copy – Enter an Channel
Group number and click
Copy to make a new Trunk
assignment with settings
copied from the Channel
Group entered.
• Delete – Delete an Trunk
(Trunks 1~128 for CTX670 and 1~32 for CTX100).
4. Enter data.
5. Click Submit.
F
IELD
Channel Group
01 RPTU Equipment No.
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
100 on page 4-1
"PRI Trunks
on page D-29.
D
ESCRIPTION
Channel Group Number
Possible values: 1~32 (CTX100), 1~48 (CTX670 Basic), 1~128 (CTX670 Exp),
Enter the ISDN RPTU equipment number as xxyyzz.
Possible values: xx = cabinet 01; yy = 03, 05, or 07; zz = Circuit 01
Note zz = Channel 01 is always used to assign RPTU parameters
Example: If the RPTU is installed in cabinet shelf 5, slot 3, enter 050301.Enter the
equipment number xxyyzz to which the ISDN PRI Trunk is to be assigned.
Equipment numbers are required when assigning ISDN RPTU parameters in the
system. It can also be used to display the equipment location of existing RPTU
PCBs.
"Call-by-Call" on page 6-29. Therefore, ILG and OLG must
(default = no value)
...or xx = cabinet 02~07; yy = 01, 03, or 05; zz = Circuit 01
(default = no value)
Trunks
ISDN
5722
6-25