Toshiba Strata CTX Programming Manual page 274

Maintenance
Components
Table 11-2
Component Type
Expansion Cabinet
Line/Station/Option PCB
Port (ISDN)
Port (ISDN)
Port (ISDN)
Port (ISDN-U)
Port (ISDN-U)
Port (ISDN-U)
Port (ISDN-U)
Port (T1)
Port (T1)
Port (T1)
Port (DKT)
Manual Disable/Enable
The components screen enables you to enable or disable any card slot or port.
• When disabled by Disable or Forced Disable, line or stations are made busy and the status will display
"disable by cmd" on the screen. On the telephone LCD, it will display "Make busy."
• Disable will disable an idle port or slot and cause ports/slots that are in use to go to Pending Disable
– which go to Make Busy after they go idle. Disable waits till a call clears to disable it.
• Forced Disable will disable an idle port or a port that is in-use (the call will be disconnected).
• Enable – removes the Make Busy condition if the slot or port is manually disabled.
Note You cannot enable a slot or port if the system automatically disabled it. The status on the screen will
display "Disabled by Fault."
11-8
Status Column Error Codes
Status Code
CP Cabinet power failure
CR Card PCB set in Program 100, but not installed
IL ISDN loss of signal
IF ISDN frame sync failure
IA ISDN AIS
UM ISDN-U maintenance mode
UE ISDN-U Eoc maintenance mode
UA ISDN-U Act
UB ISDN-U aib
TY T1 Yellow alarm
TB T1 Blue alarm
TF T1 Frame sync. failure
DO Digital Telephone not connected.
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
Description