Service; Disa Security Code; Intercept Treatment - Toshiba Strata CTX Programming Manual

Service

Programs Used: 311 and 319
These commands assign Assigns Direct Inward System Access (DISA) properties.
1. From the Program Menu, click
Trunk > Service. The Trunk
Services screen displays (shown
right).
2. Enter Program 311 data.
3. Enter Program 319 data.
4. Click Submit.

311 DISA Security Code

Prerequisite Program:
Assigns DISA parameters.
F
IELD
01 DISA Enabled
02 DISA Code
03 Response Timer
04 Idle Timer

319 Intercept Treatment

Prerequisite Program:
This command assigns Intercept positions for Strata CTX Day/Night schedules. Intercept positions are
used when the destination of a trunk line call is not determined with DID or DIT.
F
IELD
01 Day1 Destination Type
02 Day2 Destination Type
03 Night Destination Type
Day1 Destination
Day2 Destination
Night Destination
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
None
D
ESCRIPTION
Enable DISA security code.
Possible values: Enable or Disable (default)
Enter DISA security code.
Possible values: Up to 15 digits (default = no value)
Enter the time, in seconds, for Strata CTX to respond to a call.
Possible values: 0~30 (default = 5)
Enter the time in seconds to wait for idle DTMF.
Possible values: 0~60 (default = 10)
None
D
ESCRIPTION
Select Destination Type for each.
Possible values: None (default), Dialing Digits or Night Bell
Enter Destination for each.
Possible values: Up to 32 ASCII characters (default = no value)
•
To intercept with a DN use 0~99999
•
To intercept with a Network DN use 1~32
• To intercept with Dial Digits Paging 1~16
Trunks
Service
6-19