D-Link DWL-8600AP User Manual page 212

Dws-4000 series access points

Hide thumbs Also See for DWL-8600AP:

Table of Contents

D-Link UWS User Manual

Configured Ports

Active Ports

Load Balance

Table 102: Port Channel Status Fields (Cont.)

Select enable or disable from the pulldown menu. When the Port Channel is

disabled no traffic will flow and LACPDUs will be dropped, but the links that

form the Port Channel will not be released. The factory default is enable.

Indicates whether the link is Up or Down.

Shows whether the Spanning Tree Protocol () Administrative Mode is enabled

or disabled on the port channel

Shows whether static mode is enabled for this port channel.

Shows whether to send traps when link status changes. If the status is

Enabled, traps are sent.

Lists the ports that are members of the Port Channel, in Slot/Port notation.

There can be a maximum of 8 ports assigned to a Port Channel.

Lists the ports that are actively participating members of this Port Channel, in

Slot/Port notation.

Shows the hashing algorithm used to distribute the traffic load among

available physical ports in the LAG. The range of possible values may vary with

the type of switch. The possible values are:

• Source MAC, VLAN, EtherType, and source port

• Destination MAC, VLAN, EtherType and source port

• Source/Destination MAC, VLAN, EtherType, and source port

• Source IP and Source TCP/UDP Port

• Destination IP and Destination TCP/UDP Port

• Source/Destination IP and source/destination TCP/UDP Port

Creating Port Channels (Trunking)

Unified Wired and Wireless Access System

Show Quick Links

Table of Contents