Cos Interface Queue Configuration; Figure 222: Interface Queue Configuration; Table 203: Interface Queue Configuration Fields - D-Link DWL-8600AP User Manual

D-Link UWS User Manual

CoS Interface Queue Configuration

Use the CoS Interface Queue Configuration page to define what a particular queue does by configuring switch
egress queues. User-configurable parameters control the amount of bandwidth used by the queue, the queue
depth during times of congestion, and the scheduling of packet transmission from the set of all queues on a
port. Each port has its own CoS queue-related configuration.
The configuration process is simplified by allowing each CoS queue parameter to be configured globally or per-
port. A global configuration change is automatically applied to all ports in the system.
To display the Interface Queue Configuration page, click LAN > QoS > Class of Service > CoS Interface Queue
Configuration in the navigation menu.
Field
Interface
Minimum Bandwidth
Allocated
Queue ID
Minimum Bandwidth
D-Link
Oct. 2015

Figure 222: Interface Queue Configuration

Table 203: Interface Queue Configuration Fields

Description
Specifies the interface (physical, LAG, or Global) to configure.
Shows the sum of individual Minimum Bandwidth values for all queues in the
interface. The sum cannot exceed the defined maximum of 100. This value is
considered while configuring the Minimum Bandwidth for a queue in the
selected interface.
Use the menu to select the queue per interface to be configured.
Specify the minimum guaranteed bandwidth allocated to the selected queue
on the interface. Setting this value higher than its corresponding Maximum
Bandwidth automatically increases the maximum to the same value. The
default value is 0. The valid range is 0 to 100, in increments of 1. The value zero
(0) means no guaranteed minimum. The sum of individual Minimum
Bandwidth values for all queues in the selected interface cannot exceed
defined maximum 100.
Configuring Class of Service
Unified Wired and Wireless Access System
Page 339