Table 223: Captive Portal Global Configuration - D-Link DWL-8600AP User Manual

D-Link UWS User Manual
The following table describes the global CP fields you can view or configure.
Field Description
Enable Captive Select the check box to enable the CP feature on the switch. Clear the check box to
Portal disable the captive portal feature.
CP Global Shows whether the CP feature is enabled.
Operational Status
CP Global Disable If CP is disabled, this field displays the reason, which can be one of the following:
Reason
• None
• Administratively Disabled
• No IPv4 Address
• Routing Enabled, but no IPv4 routing interface
Additional HTTP HTTP traffic uses port 80, but you can configure an additional port for HTTP traffic. Enter
Port a port number between 0-65535 (excluding ports 80, 443, and the configured switch
management secure port).
Additional HTTP HTTP traffic over SSL (HTTPS) uses port 443, but you can configure an additional port for
Secure Port HTTPS traffic. Enter a port number between 0-65535 (excluding ports 80, 443, and the
configured switch management secure port).
Peer Switch When clustering is supported on the switch, enter a value to determine how often the
Statistics Reporting switch sends its authenticated client statistics to the Cluster Controller. The interval is in
Interval seconds. Enter a value of 0 to prevent the switch from reporting the statistics.
Authentication To access the network through a portal, the wireless client must first enter
Timeout authentication information on an authentication Web page. Enter the number of
seconds to keep the authentication session open with the client. When the timeout
expires, the switch disconnects any active TCP or SSL connection with the client.
D-Link
Oct. 2015

Table 223: Captive Portal Global Configuration

Captive Portal Configuration
Unified Wired and Wireless Access System
Page 385