D-Link UWS User Manual
Valid Access Point Summary
The Wireless Global Configuration page contains a field to select whether to use a local or RADIUS database
for AP Validation. The Valid Access Point Summary page contains information about APs configured in the
local database. If the AP Validation is set to RADIUS, information about the APs to be managed by the switch
must be added to the external RADIUS database.
You can add an AP into the local list of Valid APs from the WLAN > Administration > Basic Setup > Valid AP
tab, as the following figure shows, or you can add an AP from the AP Authentication Failures or Rogue AP/RF
Scan lists.
Field
AP Database
Managed AP
Rogue AP
Standalone AP
MAC Address
Location
AP Mode
D-Link
Oct. 2015
Figure 365: Adding a Valid AP
Table 333: Valid Access Point Summary
Description
Identifies the total number of APs that have been added to the AP database.
Identifies the number of APs in the database with an AP Mode set to Managed.
Identifies the number of APs in the database with an AP Mode set to Rogue.
Identifies the number of APs in the database with an AP Mode set to Standalone.
Enter the MAC address of the AP in this field. When you add the MAC address, you
add the AP to the local database on the switch.
Enter a location to help identify the AP. This field is optional and accepts up to 32
alphanumeric characters, including special characters.
This field displays the current mode of the AP, which can be one of the following:
• Managed
• Standalone
• Rogue
To configure a different mode, click the MAC address of the AP to go to the Valid
Access Point Configuration page.
Unified Wired and Wireless Access System
Basic Setup
Page 569