Wireless Snmp Trap Configuration; Figure 380: Snmp Trap Configuration - D-Link DWL-8600AP User Manual

D-Link UWS User Manual
Command Buttons
The page includes the following buttons:
• Submit—Updates the switch with the values you enter. To retain the new values across a power cycle,
you must perform a save (Tool > Save Changes).
• Refresh—Updates the page with the latest information.

Wireless SNMP Trap Configuration

If you use Simple Network Management Protocol (SNMP) to manage the DWS-4000 Series switch, you can
configure the SNMP agent on the switch to send traps to the SNMP manager on your network from the
Administration > Advanced Configuration > Global > SNMP Traps tab.
When an AP is managed by a switch, it does not send out any traps. The switch generates all SNMP traps based
on its own events and the events it learns about through updates from the APs it manages.
Note: You can configure the Wireless traps only if the Wireless Trap Mode is enabled, which you
configure on the LAN > Administration > SNMP Manager > Trap Flags page.
All Wireless SNMP traps are disabled by default.
traps are disabled by default.
D-Link
Oct. 2015

Figure 380: SNMP Trap Configuration

Table 349 describes the events that generate SNMP traps. All
Configuring Advanced Settings
Unified Wired and Wireless Access System
Page 597