Siemens Sinamics S120 Function Manual page 603

● PROFIBUS interface
● PROFIBUS diagnostic LED
Note
A teleservice adapter can be connected to the PROFIBUS interface (X126) for remote
diagnostics purposes.
On the CU320-2, the PROFIBUS address is set as a hexadecimal value using two rotary
coding switches. Values between 0
The upper rotary coding switch (H) is used to set the hexadecimal value for 16
lower rotary coding switch (L) is used to set the hexadecimal value for 16
Table 10- 55 PROFIBUS address switch
Rotary coding switches
Setting the PROFIBUS address
The factory setting for the rotary coding switches is 0
There are two ways to set the PROFIBUS address:
1. Using parameter p0918
2. Using the PROFIBUS address switches on the Control Unit
Drive functions
Function Manual, (FH1), 01/2012, 6SL3097-4AB00-0BP2
The PROFIBUS interface is described in the following documentation:
References: SINAMICS S120 Equipment Manual for Control Units and Additional System
Components
Significance
16 = 16
1
16 = 1
0
– To set the bus address for a PROFIBUS node using STARTER, first set the rotary
code switches to 0
dec
– Then use parameter p0918 to set the address to a value between 1 and 126.
– The address is set manually to values between 1 and 126 using the rotary coding
switches. In this case, p0918 is only used to read the address.
(00 ) and 127
dec hex
21
dec
15
hex
1
5
(00 ) and/or 127 (7F
hex dec
10.2 Communication via PROFIBUS DP
(7F ) can be set as the address.
dec hex
.
0
Examples
35
dec
23
hex
2
3
(00 ).
dec hex
).
hex
Communication
and the
1
126
dec
7E
hex
7
E
601