Setpoint Settings - Basic Set Value Is - ABB i-bus KNX Product Manual

11.5.93 Setpoint settings - Basic set value is

Options:
Setpoint for cooling comfort:
■
– The device uses the temperature value that has been set via parameter "Setpoint
temperature for cooling comfort" (°C).
Set-point for heating comfort:
■
– The device uses the temperature value that has been set via parameter "Setpoint
temperature for heating comfort" (°C).
Mean value between heating comfort and cooling comfort:
■
– The device uses the mean value of the two specified setpoints.
The RTC requires a defines basic set value for its function. The parameter is used to specify the
set value the device accesses.
Note
The parameter can only be set when the "Setpoint heating comfort = Setpoint
cooling comfort" parameter is set on "No".
Product manual 2CKA001473B9482
Description of application and parameters
Set-point for cooling comfort
Set-point for heating comfort
Mean value between heating comfort and cooling comfort
Application "Function block RTC"
│110